2 mm Desoldering Wick (1.5 m)

Overview

This is 2mm Desoldering Wick (1.5 m) CP-2015 non-halogen, low residue, no-cleaning tin suction tape, necessary for cleaning pads. Suitable for removing excess solder.

The tin suction tape is a braided metal wire tape that can absorb molten solder by capillary action. It is used to absorb excess solder when removing tin, is resistant to oxidation and corrosion, has good thermal conductivity and clean tin absorption. Remove the desoldering points of the motherboard and use it with the soldering station.

The tin strip is refined with pure copper and special chemical formula to ensure fast, good and economical. It is used to absorb excess solder when removing tin, is resistant to oxidation and corrosion, has good thermal conductivity and clean tin absorption. In desoldering, after the chip is removed, there will be a large amount of solder on the circuit board, which will affect the soldering of the chip. Usually use suction tape to clean, the method is to put the soldering iron on the suction tape and slowly move it on the chip pad, when the solder melts, it will be sucked up by the tin suction tape, suck the tin between the feet, so it can be cleaned. Afterwards, it is best to wash the chip position of the machine board thoroughly with washing water. Suction tape can be used for larger SMD components! In the tin removal tool, the tin suction device can be used for general aluminum electrolytic capacitors, and the tin suction tape can be used for larger SMD components. No cleaning, cut off the sucked section after each use and reuse it.

Features

1. This "Solder WICK" is made of pure copper and special chemicals to ensure good, fast and economical use.

2. Used to absorb excess solder when removing tin, it is resistant to oxidation and corrosion, thermal conductivity and tinning effect are very good, and the tin is clean.

3. The width is 2.0 mm, the length is about 0.75 meters.

Don't delay. Buy today.

Add to cart now!