VNH2SP30 Dual Motor Driver Shield

Overview

This driver is ideal for a robot using medium power motors with two channels. It is also pine-pin compatible with Arduino Uno.

To use the driver at full capacity, it is recommended to mount a radiator or cooler.

This module is designed for high-horsepower motor drive. The powerful performance of the module makes it only need a pair of VNH2SP30 to replace the L298 H bridge to provide full-bridge motor drive. At the same time, we have strengthened the load capacity of the circuit so that it can be driven A pair of high-current motors! Both the module input end and the motor interface end use 5mm interface terminals, making it easy to connect large-size wires. When ultra-high current is required, the wires can be directly welded to the module instead of connecting with terminal blocks (depending on the situation).

Note: When the drive current is greater than 6A, the chip will heat up. In order to improve performance, it is best to connect a heat sink or cooling fan.

Specifications

• Maximum supply voltage: 16 V
• Minimal alert voltage: 5.5 V
• Maximum current / channel: 14 A
• Maximum current / spike channel: 30 A
• Maximum PWM Frequency: 20 kHz
• Protection against: over-temperature, over-voltage, under-voltage
• Dimensions: 5.9 cm x 5.3 cm

Don't delay, buy today.

Add to cart now!